综合久久久久久98,中文字幕不卡二区,亚洲中文字幕无码爆乳av,亚洲老熟女性亚洲,亚洲爆乳成av人在线视菜奈实

1~4

P1_0~P1_3

GPIO mode default, input or output (push-pull), the state after power on is decided by AD1 and AD0 terminals. Can be configured as LED mode.

默認GPIO模式，輸入或輸出（推挽結構），上電默認狀態由AD1和AD0決定?？稍O置為L(cháng)ED模式。

5~8

P0_0~P0_3

GPIO mode default, input or output (open-drain (default) or push-pull), the state after power on is decided by AD1 and AD0 terminals. Can be configured as LED mode.

默認GPIO模式，輸入或輸出（開漏結構（默認）或推挽結構），上電默認狀態由AD1和AD0決定?？稍O置為L(cháng)ED模式。

9

GND

Ground. 地

10~13

P0_4~P0_7

GPIO mode default, input or output (open-drain (default) or push-pull), the state after power on is decided by AD1 and AD0 terminals. Can be configured as LED mode.

默認GPIO，輸入或輸出（開漏結構（默認）或推挽結構），上電默認狀態由AD1和AD0決定?？稍O置為L(cháng)ED模式。

14~17

P1_4~P1_7

GPIO mode default, input or output (push-pull), the state after power on is decided by AD1 and AD0 terminals. Can be configured as LED mode.

默認GPIO，輸入或輸出(推挽結構), ，上電默認狀態由AD1和AD0決定?？稍O置為L(cháng)ED模式。

18

AD0

I²C device address, connect to VCC or GND，and control the default state of GPIOs (see table 1)。

I²C器件地址選擇，接VCC或GND，并設置GPIO狀態（見表1）。

19

SCL

I²C serial clock. I²C時鐘

20

SDA

I²C serial data. I²C數據

21

VCC

Power supply. 電源輸入端.

22

INTN

Interrupt output pin, open-drain, need external pull-up resistor; active low.

中斷輸出，開漏結構，需外部上拉電阻；低有效

23

RSTN

Hardware reset pin, active low; internal 100 kΩ (typical) pull-down resistor.

硬件復位，低為復位；內部下拉100 kΩ（典型值）電阻

24

AD1

I²C device address, connect to VCC or GND，and control the default state of GPIO (see table 1)。

I²C器件地址選擇，接VCC或GND，并設置GPIO狀態（見表1）。

EP

GND

Provides both electrical and thermal connection from the device to the board. Connect to the system ground. 接地。